Advertisement
Quick Links
RC Conversion Kit for TAMIYA
1/35 T55A
User Manual (Version 1.0)
Attention!
1) This kit is designed for experienced model makers. It may be
difficult for beginners. Please read this manual thoroughly to see
if you have the required skills and tools.
2) Cutting tools are used frequently in this kit. Extra care should be
taken to avoid injury. Wear hand gloves and eye protection
spectacle if necessary.
3) Keep room well ventilated when working with cements, paints
and organic solvents.
4) Visit www.35rctank.com for addition tips and update information.
side cutter
modelling knife
carving knife
all purpose glue
hand saw
both sides
Attention!
(Item no: 35257)
apply cement
do not apply cement
apply instant glue
solder
apply lubrication oil
polish with sand paper
Copyright 2017 www.35rctank.com
Page 1
Advertisement
Related Manuals for Tamiya T55A
Summary of Contents for Tamiya T55A
- Page 1 RC Conversion Kit for TAMIYA 1/35 T55A (Item no: 35257) User Manual (Version 1.0) Attention! 1) This kit is designed for experienced model makers. It may be difficult for beginners. Please read this manual thoroughly to see if you have the required skills and tools.
- Page 2 Lower hull lower hull lower hull inside to make room for torsion bars, remove 0.5mm make round holes with a circular file remove remove make slot for sprocket set screw Torsion bars 4.5mm spacer torsion bar mount (L) 4.5mm spacer torsion bar mount (R) 4.5mm spacer Copyright 2017 www.35rctank.com...
- Page 3 Torsion bars metal torsion bar drill 1.2 x 8mm deep hole cut 0.3mm slot A12, A13, A36, A37 insert torsion bars into slot insert torsion bars into slot Gearbox Copyright 2017 www.35rctank.com Page 3...
- Page 4 Sprocket and wheels remove for smooth wheel rotation, enlarge hole with 4.2 drill do not insert polycap Turrret ring gear remove turret ring gear For smooth turret rotation, remove sharp edges with abrasive paper Attach B9 temporary for alignment upper hull Turret ring gear Speaker 1mm PS partition plate...
- Page 5 Connecting upper and lower hull 1mm PS plate 1mm PS plate attach to lower hull Main gun Drill 2.5mm through hole remove enlarge hole for recoil spring metal barrel alignment mark Copyright 2017 www.35rctank.com Page 5...
- Page 6 Main gun turret servo assembly insert barrel and secure set screw recoil spring Turret servos attach to upper turret Drill 4.5mm screw holes Main gun LED M2x5 press fit here, do not apply adhesive LED expose during recoil Copyright 2017 www.35rctank.com Page 6...
-
Page 7: Acu Connections
Attach turret M2x5 ACU mount ACU connections notice cable positions keep cables away from moving parts secure ACU with M1.7 screws secure cables with adhesive tape Install MTC-2 mini tank controller Secure MTC-2 MTC-2 mount by M2 x 5 screws MTC-2 power switch (make opening in lower hull is optional) Copyright 2017 www.35rctank.com... - Page 8 Lower hull connections secure cable with adhesive tape 1 Cell 3.7V Lipo battery Spektrum 2.4G (300 - 1000mAh) AR6110e micro receiver carboard Main gun search light remove press fit to C15 do not apply cement search light mount Using Lipo battery Lipo battery can be dangerous if not use properly! Follow all safety precautions and always use a dedicated Lipo charger.