Using Tcp/Ip - Ricoh SP 3400N Operating Instructions Manual

Using TCP/IP

To connect the printer via TCP/IP, you must complete the following four steps.
A
Print the test page
B Install Smart Organizing Monitor if necessary
C Specify the printer's IP address if necessary
D
Add the printer using [Printer Setup Utility]
Note
❒ If the printer is obtaining its IP address automatically from a DHCP serv-
er, you do not need to perform "2. Install Smart Organizing Monitor" and
"3. Specify the printer's IP address".
Printing a test page
To install the printer driver, you must first confirm the printer's IP address.
Make sure the network cable is properly connected to the printer before you
print the test page.
A
Turn the printer's power switch to off, and then wait a few seconds.
B
While pressing down the {Job Reset} key, turn the printer's power switch
back to on, and then keep the key pressed down until the Alert indicator
flashes once.
C
Printing starts when the printer is fully warmed up.
Printing starts approximately 30 seconds after the Alert Indicator starts blinking.
Note
❒ If the printer is obtaining its IP address automatically from a DHCP server,
you do not need to install Smart Organizing Monitor separately. Proceed
to p.83 "Setting Up the PPD File" and add the printer.
❒ If the printer cannot obtain its IP address from a DHCP server, install
Smart Organizing Monitor and specify the IP address, before adding the
printer.
❒ You can also use Web Image Monitor to change the IP address obtained
from a DHCP server. To access Web Image Monitor, use the IP address
printed on the test page.
Reference
For details about Web Image Monitor, see p.37 "Using Web Image Monitor".
For the installation procedure, see p.89 "Installing Smart Organizing Moni-
tor".
Specifying the Printer
81
7