Protocol Setup (Tcp/Ip) - Ricoh Fiery 3850C Configuration Manual

4
4-10 Setting up the Fiery 3850C from a Windows Computer

Protocol Setup (TCP/IP)

—Click to enable if you have a TCP/IP network connected to the
Enable on Ethernet
Fiery 3850C over Ethernet cabling.
You must enable TCP/IP for Ethernet to use the Fiery WebTools over Ethernet. If you
are using TCP/IP for printing from Windows NT 4.0/2000 workstations, enabling
TCP/IP here also enables you to use Fiery utilities from Windows NT 4.0/2000
workstations using TCP/IP protocols.
—Click to allow the Fiery 3850C to obtain its Ethernet IP address
IP Auto (Ethernet)
by searching the network. Depending on your network and the protocol you select
(DHCP, BOOTP, or RARP), the IP address can change.
—Select the protocol over which the Fiery 3850C should
Select protocol (Ethernet)
search for its IP address. Both DHCP and BOOTP allow the Fiery 3850C to obtain
the Ethernet IP address and Subnet Mask automatically. RARP obtains only the
Ethernet IP address.
Depending on your network, the Fiery 3850C might be assigned a different address
after you reboot the Fiery 3850C. With the DHCP setting, the Fiery 3850C can be
assigned a different address even if it is not rebooted. Make sure the network is already
configured properly for the protocol you select.