HP EliteDesk 705 G2 Maintenance And Service Manual page 40

The primary Serial ATA (SATA) hard drive must be connected to the dark blue primary SATA connector on
●
the system board labeled SATA0.
Connect secondary hard drives and optical drives to one of the light blue SATA connectors on the system
●
board (labeled SATA1 and SATA2).
● HP has provided four extra 6-32 hard drive mounting screws installed on the front of the chassis next to
the hard drive bays (1). If you are replacing a hard drive, remove the mounting screws from the old drive
and install them in the new drive.
CAUTION:
If you are inserting or removing a drive, shut down the operating system properly, turn off the computer, and
unplug the power cord. Do not remove a drive while the computer is on or in standby mode.
Before handling a drive, ensure that you are discharged of static electricity. While handling a drive, avoid
touching the connector. For more information about preventing electrostatic damage, refer to
discharge information on page
Handle a drive carefully; do not drop it.
Do not use excessive force when inserting a drive.
Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic fields such as
monitors or speakers.
If a drive must be mailed, place the drive in a bubble-pack mailer or other protective packaging and label the
package "Fragile: Handle With Care."
32 Chapter 4 Removal and replacement procedures – Microtower (MT) chassis
To prevent loss of work and damage to the computer or drive:
11.
Electrostatic