Assembly & Operation - MasterCraft 54-8333-2 Owner's Manual

ASSEMBLY AND OPERATION – MULTI-CUTTER
This multi-cutter precision saw is a versatile
tool that is designed for use in confined
work spaces. By selecting the appropriate
cutting blades, it will cut copper and
aluminum tubing, ceramic and marble tile,
and assorted wood products. The
accessory spirit/laser level will also function
as a handy mitre guide for scribing cutting
marks for most common angles on the
workpiece. The following assembly and
operating instructions will explain the tool
and spirit level in detail.
INSTALL VACUUM ADAPTOR
The vacuum adaptor can be used to attach
a workshop vacuum hose to the tool. This
will prevent most cutting dust from
escaping into the work area.
1. Line up the tabs on the small end of
the vacuum adaptor (1) with the
matching slots (2) in the vacuum port
(3) in the rear of the tool (see Fig. 1).
2. Push the vacuum adaptor into the
vacuum port as far as it will go.
3. Twist the vacuum adaptor clockwise to
lock it into position.
Fig. 1
SECURE CORD TO VACUUM HOSE
Slide the hook and loop strap (1) down the
power cord (2) and wrap it around the
vacuum hose (3) (see Fig. 2).
REMOVE BLADE GUARD
1. Insert 5 mm hex key (1) into the blade
guard fulcrum nut (2) (see Fig. 3).
2. Turn hex key counter clockwise to
remove the blade guard fulcrum nut.
3. Slide blade guard fulcrum bolt (3) out
of the blade guard (4).
4. Carefully slide the blade guard off the
tool.
REMOVE BLADE
!
WARNING:
from the power source before making
any adjustments or changing the blade.
!
WARNING:
careful when handling blades. They will
be extremely hot immediately after use.
They are also very sharp and may cause
serious injury.
1. Insert the 5 mm hex key (1) into the
arbor screw (2) on the LEFT side of
the tool (see Fig. 4).
11
Fig. 2
Fig. 3
Always unplug the tool
Always be extremely