Assembly - MasterCraft 55-6863-0 Operating Manual

ASSEMBLY

UNFOLDING AND SETTING UP THE MITRE-SAW STAND
1. After taking the Mitre-Saw Stand out of carton, place it flat on floor, as shown
(Fig.3).
Fig. 3
2. Hold the yellow Locking/Carrying Handle (5) and the
Assembly (7), and unlock the yellow Locking/Carrying Handle (5) by pulling the
handle towards the operator
3. Grasp the other bar and lift the Tabletop Assembly up, as shown in Fig. 5.
4. Continue to lift the Tabletop Assembly while the Base remains in place on the
floor, as shown in Fig.6.
Fig. 4
5. Continue to lift the Tabletop Assembly until the Tabletop Assembly is completely
vertical. (Fig. 7).
6. Hold the Base Bar Legs (as shown) by placing a foot on the Base Bar. Pull the
Tabletop Assembly straight up until the Chrome Extension Bars (4) attached to
the Table Top-Assembly, are fully extended. Be sure that the Chrome Extension
Bars lock in place (Fig. 8).
7. With one foot still on the Base Bar, grasp the Support Bar (8) and pull it up until
its Chrome Extension Bars are also fully extended and they lock in place. Pull
the legs further apart to form an "X" (Fig. 9).
Fig. 7
(Fig. 4).
Fig. 5
Fig. 8
right side of the Table
Fig. 6
Fig. 9
12