Table of Contents
Advertisement
CIRCLE CUTTING GUIDE OPERATION
Unplug the tool from the power source before
changing accessories, changing bits and making
adjustments.
Before turning the tool ON, check to make sure bit
and all accessory fasteners are securely tightened.
1. Mark the centre of the circle you wish to cut on the
workpiece and drill a 6 mm or
2. Adjust cutting bit depth to
thickness of the material being cut (see Fig. 5).
3. Adjust the circle cutting guide radius by loosening
pivot point knob, sliding it to the correct circle radius
and re-tightening in the desired location.
NOTE: Check circle cutting guide radius setting by
measuring from the pivot point to the outside of the
spiral bit.
4. Rest the edge of the freehand cutting guide on the
workpiece with the bit at an angle of about 45
Fig. 13). Insert the circle cutting guide pivot point into
the pilot hole drilled at the centre of the circle.
NOTE: DO NOT let the bit contact the workpiece
before switch is turned ON and the tool is up to full
speed.
15
/
" pilot hole.
64
1
/
" longer than the
8
0
(see
Advertisement
Table of Contents
