MasterCraft 54-8333-2 Owner's Manual page 17

ASSEMBLY AND OPERATION – SPIRIT/LASER LEVEL
The spirit/laser level is a dual purpose tool
and can be used in the following modes:
●
Spirit/laser level that will project either
a needle beam (fine point) or a
horizontal line.
●
Mitre gauge for marking cutting angles
on ceramic tile, wood etc.
LASER LEVEL
INSERT BATTERIES (not included)
!
WARNING:
switch is in the OFF position before
inserting batteries. The laser light
contacting the eyes may cause serious
injury.
Before the laser level will operate, two
"AAA" alkaline batteries must be installed.
Batteries must be fresh and in good
condition to provide the brightest laser
beam.
1. Locate the battery box cover (1) on the
side of the laser level (see Fig. 12).
2. Pull back on the battery box cover tab
(2) to release the cover.
3. Lift upward on the battery box cover to
expose the empty battery box.
Install TWO new "AAA" batteries.
4.
NOTE: Be sure to install the batteries
correctly by using the battery
illustrations on the battery box cover
(3) as a guide.
5. When batteries are correctly installed,
replace the battery box cover. Press
on the latch end of the door until the
latch clicks into place and holds the
battery box cover firmly closed.
Always make sure the
Fig. 12
ON/OFF SWITCH
!
WARNING:
light toward a person. The laser light
contacting the eyes may cause serious
injury.
The ON/OFF switch is located in end of the
laser level (see Fig. 13).
1. Press the bottom of the switch (1) to
turn the laser beam ON.
2. Press on the top of the switch (2) to
turn the laser beam OFF.
3. Slide the laser shape control (3) up or
down to generate the shape of beam
required (see Fig. 15 & 16).
17
Never point the laser
Fig. 13