Specific Safety Rules; Extension Cords - MasterCraft 54-8333-2 Owner's Manual

!
WARNING:
precision saw. Read the Owner's
Manual carefully. Learn the tool's
applications and limitations, as well as
the specific potential hazards related to
this tool. Following this rule will reduce the
risk of electric shock, fire and serious
injury.
Always wear eye protection. Any power
tool can throw foreign objects
into your eyes, which could
cause permanent eye
damage. ALWAYS wear safety
goggles (not glasses) that comply with
ANSI safety standard Z87.1. Everyday
glasses only have impact resistant lenses.
They ARE NOT safety glasses.
!
WARNING:
that do not comply with ANSI Z87.1
could cause serious injury if they break.
Always wear hearing protection and a
dust mask. Dust and high-pitched noise
created when using this high-speed saw
can damage your hearing and lungs.
Do not wear gloves, neckties or loose
clothing.
Always keep hands out of the path of the
saw blade. Avoid awkward hand positions
where a sudden slip could cause your hand
to move into the path of the saw blade.
Do not cut material too small to be
securely held.
Secure workpiece. Use clamps or a vice
to hold the work when practical. Both
hands are required to operate the tool.
Make sure there are no nails or foreign
objects in the area of the workpiece to be
cut.

SPECIFIC SAFETY RULES

Know your multi-cutter
Glasses or goggles
SAVE THESE INSTRUCTIONS FOR REFERENCE
To avoid injury from accidental starting,
always remove the plug from the power
source before making any adjustments or
installing / removing a saw blade,
accessory or attachment.
!
DANGER:
that is projected from the front of the
laser level can be dangerous to
eyesight. Never allow anyone to stare
directly into the light. Staring directly
into the light beam may result in serious
eye damage.
!
DANGER:
level in the presence of small children.
Small children may stare directly into the
laser light beam causing serious eye injury.

EXTENSION CORDS

!
WARNING:
cord clear of the working area. Position
the cord so that it will not get caught on
the workpiece, tools or any other
obstructions while you are working with
the power tool.
Make sure any extension cord that is
used with this tool is in good condition.
When using an extension cord, be sure to
use one that is heavy enough to carry the
current that the tool will draw. An
undersized cord will cause a drop in line
voltage which will result in loss of power
and overheating.
The table on the following page shows the
correct size to be used according to cord
length and nameplate ampere rating. When
in doubt, use the next heavier gauge. The
smaller the gauge number the heavier the
cord.
6
The laser light beam
Never use the laser
Keep the extension