Table of Contents
Advertisement
2.
InstallatIon
2.1.
sItIng the machIne
Site the machine on a stationary, horizontal, dry base in a position that does NOT
allow dust, dirt or metal particles to enter the machines cooling air flow.
max. 15
60
0
2.2.
mountIng the control panels pl and pX
Mounting of panel should only be carried out by competent electrician.
Attention! Disconnect plug of machine from mains socket and wait for approx. 2 min
before removing cover plate.
- On the front face of machine there is a cover plate where the control panel is mounted.
Without a panel the machine is controlled either from remote control unit or Promig
or Protig unit.
- Mount PL or PX panel according to mounting instructions delivered with them.
2.2.1. Connection to the mains supply
Kemppi Pro Evolution power sources are delivered equipped with 5 m mains cable without plug.
If local electricity regulations of operating country are stating otherwise, the mains cable should be
replaced in conformity with the local regulations.
Connection of the mains cable, mounting and change of the plug should only be carried out by a
competent electrician.
Remove the machine's right side plate to enable the mounting of a mains cable.
© Kemppi oy
- Preferably site the machine somewhat higher above the
floor level.
- Ensure that the front as well as the rear of the machine
there is at least 20 cm free distance to allow good
0
circulation of the cooling air through the machine.
- Protect the machine against heavy rain and in hot
circumstances against direct sunshine. Ensure the free
circulation of the cooling air.
rain water
Degree of protection of machine IP23
allows at its maximum the water spray coming
in 60º angle to hit machine's outer covering.
See to that the machine is positioned away from the line of
particle spray, created by grinding tools etc.
Kemppi pro evolution 300, 400, 500, 300 mvu, 400 mvu, 500 mvu / 0617 – 7
Hide quick links:
Advertisement
Table of Contents
