AGAiT E-CLEAN MINI User Manual page 26

Table of Contents

Advertisement

TROUBLESHOOTING
Problem
Red LED stays after
power on.
1
Cannot vacuum when
2
it is turned on.
Moving backwards
after being started.
3
LED indicators keep
4
blinking GREEN after 4
hours charging.
The side brush
5
becomes crooked, not
good to sweep.
Cannot start the EC
MINI
6
EC MINI circles around
only.
7
Possible Cause
1. Battery Low condition.
2. The wheels stuck.
3. Side brushes stuck.
4. Bumper stuck.
5. EC MINI lifted up from the
floor.
The dust bin filter is not
properly installed.
EC MINI is on the floor in
darker color (it means the
reflectivity of floor is bad).
The power input could have
been interrupted during
charging.
Being used for a long time.
1. The battery is not installed
properly.
2. Battery power is low.
One of the wires of the wheels
is loosened.
-2 5 -
Solution
1. Recharge the cleaner.
2. Remove EC MINI from
obstacles.
Install the dust bin filter
properly.
Please simultaneously adjust
the three windows of anti-cliff
sensors to the longer distance
"-> 1 -> 2 -> 3". (Please refer to
page 6.)
As long as the total charging
time of this cycle is over 4 hours,
you could start it for cleaning.
If it becomes crooked, you could
soak it in hot water to have it
recover to its original shape.
1. To install the battery
properly, please refer to page
5 for battery installation.
2. Have the battery fully
charged.
Open the wheel cover and
connect the loosened wire
of the wheel set properly or
contact your local dealer for
service.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the E-CLEAN MINI and is the answer not in the manual?

Table of Contents