Safety Notice Before using Eclean, please read the Safety Notice carefully and follow the instructions below: Forbidden Do not disassemble the product. The high voltage inside may cause severe harm. Do not place any object and do not sit on the product during operation or non - operation.
Page 5
安全须知 Eclean 禁止事项 注意事项 -10° C 45° C 10 m²...
Package Content \ \ 包装内容 \ Eclean Main Body Remote Control Filter Cotton x 2 Eclean \ EClean x 2 \ x 2 \ \ Eclean Rechargeable Battery Adapter Recharging Dock Cleaning Brush Dust Bin User’s Manual...
Main Body \ \ 主体 \ 1 Remote control receiving port \ 5 Operation Panel \ 6 Button for removing dust bin \ 2 Collision pane \ PUSH PUSH 7 Remote control \ 3 Dust bin and Freshener /odor buster &...
Page 9
Ultraviolet light \ Front wheel \ Air outlet \ Roll brush \ Battery cove \ Side brush \ Recharging dock connection Dust suction entrance \ point \ Back wheel set \...
Battery Installation \ \ 电池安装 Push down \ Step 1 Step 2 Pull Up \ Affix \ Put back the cover \ Step 3 Step 4...
Page 11
Notice \ \ 注意 \ Only use factory-installed battery and adapter. Do not touch the battery, the adapter and/or the plug with wet hands. Ensure the adapter is firmly plugged in and do not exposure the plug. Before recharging, ensure the voltage and ampere specification matches the specification in your home.
电池充电 \ If the Low-Battery Indicator (LOW.BATT) is flashing red (i.e. low power), please use recharging dock or adapter included with Eclean for recharging. Recharging the battery takes about 3 hours. To avoid overcharging, please disconnect the recharging dock or adapter after recharging is completed to ensure longer battery life.
Page 13
Notice \ \ 注意 \ When using Eclean for the first time, please charge the battery for 8 full hours. Please make sure that the power indicator on Eclean flashes blue while charging. After the battery is fully charged, the power indicator should remain on continuously.
Operating Panel Introduction \ 主机操作面板 \ 1 Malfunction indicator\ 6 Display operation time/mode\ 2 Vacuum on/off indicator\ 7 Timer(* Unit: 10 minutes)\ : 10 3 UV light indicator\ 8 Start/Stop button\ 4 Battery/Charge indicator\ 9 Power switch\ 5 Low-battery indicator\ EC 01 EC 01 En h a n c e d...
Page 15
VAC OFF Vacuum is off ERROR Collision panel is stuck with foreign object for over 3 seconds Wheel (s) is stuck for over 10 seconds Eclean is lifted for over 3 seconds Flashing Red LOW BATT Low-battery indicator POWER ON CHARGE...
Page 16
Alarm Note \ \ 提示音说明 \ Alarm Note 1 short beep,1 long beep Vacuum timer is up; low-battery indicator is on; vacuum is off 1 long beep Indicator is on 3 short beep Fully charged 3 short beep, 1 long beep Fully charged, starts clean again...
Page 17
Safety Detection \ \ 安全侦测 \ 1. When Eclean is lifted or when 2. Eclean is designed with cliff sensor. a foreign object is entangled, Eclean can detect the edge of a Eclean sounds the alarm and the stairway and avoid falling over warning light is on.
Page 18
(Time display will resume Open space or automatically in Polygonal empty space 10 seconds.) Ramdom Wander Spiral Along Wall Spiral “S” shape Spiral Polygonal Spiral Notice In Spiral mode, Eclean will stop moving if comes in contact with any object.
80% full. indicator will display After Eclean is fully recharged, the alarm status) will sound 3 short beeps and Eclean will be on standby. P OW ER( " G O " 8 0 %...
1. Find a suitable wall outlet. Do not place anything near the recharging dock. 2. Lay the mobile base of the recharging dock against the wall. Connect to adapter power, use the other end and plug into the power input hole. Tie up wires to prevent obstructing Eclean’s movement. Eclean...
Page 24
Home Test \ \ 自动返回充电座测试 \ Place Eclean near the recharging dock. Turn on Eclean and press Start. After making sure it is operating normally, press HOME on the remote control and Eclean will start Auto-return function. You can check if the location for the recharge dock is appropriate. If Eclean cannot successfully reach the recharging dock, then adjust the location of the dock.
Page 25
Do not place objects near the recharging dock to avoid obstructing Eclean returning to the recharging dock. To ensure longer battery life, please fully discharge Eclean and charge it for 8 hours once a month. Eclean...
Eclean will start cleaning when the battery is fully charged. • Day display (top) ”Su”, “Mo”, ”Tu”, “We”, “Th”, “Fr”, and “Sa” indicate each day in a week. • CLK (right) indicates time-setting mode. • Brush icon (right): indicates Eclean will start cleaning at scheduled time.
Page 28
2. Managing schedule \ Setting the clock \ \ 设置时钟 \ 2.1. Eclean will automatically enter clock display mode upon your first use.Default time is Sunday, 00:00 (24-hour mode). 00:00 Eclean 00:00 24 Eclean 00:00 (24 2.2. Press “SET” button to set time (the display shows SET and CLK icons).The time screen starts flashing.Press “Hr”,...
Page 29
Scheduling cleaning \ \ 设置清洁时间 \ Eclean can be scheduled to clean on daily basis or on specific days. Eclean Eclean Eclean 2.3. Press “SET” button to enter scheduling mode.Time and date screen will start flashing. The setting scheme is the same as step 2.2, but the default setting for “Wk”...
Page 30
If you want to set Eclean to clean on a specific day in a week, press “Wk” button again. “Su” (Sunday) icon will start to flash. If you want to set Eclean to clean on Sunday, press “Wk” button again within 5 seconds to stop “Su” from flashing. This indicates that Eclean has confirmed the Sunday cleaning schedule.You can...
Page 31
Eclean SET) Eclean 3. To view the scheduled cleaning time \ Press “SET” button twice to enter “Schedule Cleaning Mode” and view the scheduled cleaning tasks. “SET” 4. To cancel scheduled cleaning time \ Press “SET” button twice, then set the hour and minute until “-” is shown (see below).
Page 32
: Eclean 6. To start cleaning right away \ Press and hold “GO” button over 5 seconds to instruct Eclean to leave the recharging dock, and it will start cleaning regardless of its charging status.The “START” button on the remote control has the same function.
Page 33
7. To use the remote control to start cleaning \ You can also press “START” button to set Eclean to start cleaning tasks while it is charging at the dock. Eclean “START” Eclean START START Eclean...
Power switch \ Vacuum \ Turn on the power first, and then use the remote control to set and control the Eclean. When done with the remote control, put back onto the upper cover. OFF: Turn off Eclean. START: Start Intelligent Mode and vacuum.
You can easily take out the roll brush by pressing the side of the roll brush and then lift upward (Step1). You can easily put back the brush by making sure the holes of the roll brush lines up with the holes on Eclean (Step2). Eclean 2. Lift up \ 1.
Page 42
Cleaning the back wheels \ \ 后轮清洁 \ Step 1. Turn off Eclean button and then unscrew the back wheel cover. Step 2. Open the back wheel cover. Step 3. Secure back wheels and unplug connector. Step 4. Clean off dust, hair, or any foreign object.
2. Remove any unstable objects within cleaning area, such as vases and liquid containers. 3. If the cleaning space is smaller than 40cm in diameter, Eclean will be unable to move around. In this case, please adjust the furniture distance.
Page 44
4. Eclean will not be able to enter the designated vacuuming range or it may become stuck if the height of range is lower than 10 cm. Please prevent the entry of Eclean by blocking it with an object. Eclean...
Page 45
Eclean’s returning route, do not place anything near the recharging dock. While returning to the recharging dock, Eclean will head right and move along the wall to locate the dock. To enable Eclean to locate the dock with ease, place the dock in the lower right corner of the cleaning area, and keep a 50~100cm distance from the wall.
Q: Why the warning indictor turns on? A: These are the possible reasons: 1. Eclean has been off the ground for over 3 seconds. Please place it on the ground once more. 2. The wheels have been stuck for over 10 seconds.
1. Please keep this warranty card properly and show this warranty card when sending your Eclean for service. No warranty card will be reissued. 2. The limited warranty covered under these terms is valid only in the country where your Eclean were purchased.
2. Please fill out the warranty card with true information. The warranty card will be validated only with the dealer’s stamp. 3. Please prepare the following information when requesting service: The model number, serial number, dealer and color of Eclean. Your complete address and contact information.
Need help?
Do you have a question about the Eclean and is the answer not in the manual?
Questions and answers