Hangar 9 sopwith camel 60 arf Assembly Manual page 18

Section 3B: Electric Motor Installation

.Step 5
Build.a.wiring.harness.for.the.batteries.using.a.female.
connector.and.two.male.connectors..Follow.the.wiring..
in.the.photo.so.the.motor.sees.the.voltage.increase.of..
the.two.batteries.

.Step 6
Solder.the.appropriate.connectors.onto.the.speed.control.
Note:.If.you.only.plan.on.using.this.controller.
in.your.Sopwith,.you.can.combine.Steps.5.
and.6.by.incorporating.the.harness.with.the.
speed.control.so.the.controller.is.positioned.
in.place.of.the.single.female.connector.
18

.Step 7
Plug.the.motor.into.the.speed.control..Secure.the.batteries.
using.the.hook.and.loop.strap..Plug.the.speed.control.into.
the.receiver..Mount.the.speed.control.inside.the.fuselage.
so.it.will.not.interfere.with.the.installation.and.removal.of.
the.batteries.
Note:.Apply.a.piece.of.hook.and.loop.(not.
included).in.the.batteries.and.battery.tray.if.
you.find.the.batteries.slide.forward.or.aft.

.Step 8
Turn.on.the.radio.system..Plug.the.wiring.harness.
assembled.in.Step.5.into.the.batteries.and.speed.control..
Use.the.throttle.on.the.transmitter.to.check.that.everything.
is.working.correctly..Check.that.the.motor.is.rotating.
counter-clockwise..If.not,.follow.the.directions.included.
with.the.speed.control.to.correct.the.situation.

.Step 9
Once.the.motor.is.working.and.rotating.in.the.correct.
direction,.unplug.the.wiring.harness.for.safety.