Removing The Expansion-Card Riser - Dell PowerEdge R430 Owner's Manual

Card priority Card type
FC8 HBA (Full height)
6 1 Gb NICs (Low profile)
1 Gb NICs (Full height)
7 12 GB-SAS-HBA (Low profile)
12 GB-SAS-HBA (Full height)
8 Non-RAID HBA330

Removing the expansion-card riser

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you read the
2. Follow the procedure listed in
Steps
Holding the touch points, lift the expansion-card riser from the riser connector on the system board.
Figure 31. Removing and installing the expansion-card riser
1. expansion-card riser
3. guide pin on the system board
84
Safety instructions.
Before working inside your
Slot priority
1
2
1
2
1
Integrated Slot
system.
2. guide on the expansion-card riser
4. expansion-riser connector on the
system board
Maximum allowed
1
1
1
1
1
1