Dell PowerEdge R430 Owner's Manual page 19

Item Indicator, Button, or
Connector
3 vFlash card slot
(optional)
4 iDRAC port (optional)
5 PCIe expansion card
slots (2)
6 Video connector
7 Ethernet connector 2
8 USB connector
9 USB connector
10 System identification
button
11 System identification
connector
12 Ethernet connector 3
13 Ethernet connector 4
14 Power supply unit (PSU1
and PSU2)
Icon Description
Allows you to connect the vFlash card.
Dedicated management port on the iDRAC ports
card.
Allows you to connect a PCI Express expansion
card.
Allows you to connect a VGA display to the system.
Integrated 10/100/1000 Mbps NIC connector.
Allow you to connect USB devices to the system.
The port is USB 2.0-compliant.
Allow you to connect USB devices to the system.
The port is USB 3.0-compliant.
The identification buttons on the front and back
panels can be used to locate a particular system
within a rack. When one of these buttons is
pressed, the system status indicator on the back
flashes until one of the buttons is pressed again.
Press to toggle the system ID on and off. If the
system stops responding during POST, press and
hold the system ID button for more than five
seconds to enter BIOS progress mode.
To reset the iDRAC (if not disabled in F2 iDRAC
setup) press and hold the button for more than 15
seconds.
Connects the optional system status indicator
assembly through the optional cable management
arm.
10/100/1000 Mbps NIC connector.
Redundant power
supply
Non-redundant
power supply
Up to two 550 W redundant
AC power supplies.
One 450 W non-redundant
AC power supply.
NOTE: Non-redundant
power supply is
supported in systems
with cabled hard drives
and the systems with x4
backplane.
19