InFocus LP630 Service Manual page 49

Assembly Notes
♦
To install the power connector ECA, slide the metal flanges on both sides of the power connector
over the posts in the bottom case. You may need to slightly flex the bottom case to get the ECA to
snap into place. Note that a post in the bottom case also fits into a hole in the ECA.
♦
When you install the power supply, make sure the registration pins in the bottom case fit into their
matching holes on the power supply.
♦
When you fasten the heat sensor to the bottom case, make sure to route the cable next to the tabs in
the bottom case. See step 4 above.
LP630 Service Manual 49