Remove And Replace The Front And Rear Ir Ecas - InFocus LP630 Service Manual

Remove and Replace the Front and Rear IR ECAs

There is one front and one rear IR ECA (Both: 510-1606-xx) in the LP630. One is located at the front of
the projector in the center, adjacent to the lens. The other is fastened to the rear corner of the controller
ECA. The IR ECA do not include the cables that plug into the controller ECA.
1 Remove the top case see page 13).
2 Unplug the cable from the connector on the IR ECA, and then remove the single M3x6 screw that
is holding the remote control ECA in place.
Front Remote ECA
Rear Remote ECA
LP630 Service Manual 33