Remove and Replace the Leveling Foot and Rubber Feet
The leveling foot (340-0931-xx) is located on rear corner on the projection lens side. It allows the user to
adjust the horizontal tilt of the projector.
One rubber foot (328-0138-xx) fastens to the corner opposite the leveling foot. Another identical rubber
foot fastens to the end of the elevator shaft.
Replace the leveling foot
1
Place the projector upside down on the work surface.
Rotate the foot counter clockwise until the foot and its attached shaft detach from the projector.
Note that a section of the shaft is not threaded.
When you replace the foot, turn the shaft clockwise until it reaches the non-threaded area. Then
start the threads on the lower portion of the shaft. Turn the foot until it is even with the bottom of
the projector.
LP630 Service Manual
11