To prevent eye injury, wear protective eyewear before opening the lamp door. WARNING: To avoid burns, allow the projector to cool for at least 30 minutes before you open the lamp module door. Never extract the lamp module while...
Page 2
WARNING: Do not drop the lamp module or touch the glass bulb. The glass may shatter and cause injury. & IGURE Loosen the two silver screws securing the lamp to the projector IGURE Removing the lamp from the projector...
Page 3
Replacing batteries in the remote NOTE: Make sure the positive and negative ends of the batteries are installed in the correct direction.
Using the Security Lock Troubleshooting Problem: The projector is not running Problem: Projector is running, but nothing appears on the projection screen Problem: Only the start-up screen displays...
Page 6
& Problem: Color or text not being projected Problem: The screen resolution is not right Problem: Image isn’t centered on the screen Problem: Image is too wide or narrow for screen Problem: Image is out of focus...
Page 7
Problem: Image and menus are reversed left to right Problem: The projector displays vertical lines, “bleeding” or spots Problem: No sound Problem: Image is “noisy” or streaked Problem: Projected colors don’t match the computer or video play- ers colors Problem: Lamp seems to be getting dimmer...
Page 8
& Problem: Lamp shuts off Problem: The projector runs a long time after I turn it off http://www.infocus.com/service (65) 332-0659 techsupport@infocus.com 1-800-799-9911 (31) 35-647-4010...