Transit Call Control - NetComm SmartVoice Gateway Reference Manual

Transit Call Control

If you wish to restrict a general user (one who is not required to enter the PIN code) to local calls only
and prohibit him/her from making long-distance calls started with a prefix "0", do the following steps:
1. Enable the Outbound Call Control function,
2. Set the PIN code for Outbound Level 5 to blank,
3. Set the Long-Distance Control Table to correspond with the Outbound Level 5 to prohibit making any
call with the prefix "0".
NOTE: Transit Call Control is effective when it cooperate with Long-Distance
Control Table.
• Inbound Call Control: Determines when users make a phone call from a PSTN to Gateway FXO
whether or not they check the inbound PIN code while placing the phone call to VoIP network only
effective for incoming calls calling from a PSTN trunk.
• Outbound Call Control: Determines when users utilize the Gateway FXO interface to divert to PSTN
network whether or not they check the outbound PIN code only effective for outgoing calls being
diverted to a PSTN Trunk.
• PIN Code: Enter the PIN code (4-6 digits or leave blank. A blank indicates no PIN code is required at
this level. Generally, the PIN at level 5 can remain blank to simplify the phone number.)
• Enable: Enables the PIN code at each level.
• Privileges: The level is divided into 0~5 (The levels are in descending order; 0 stands for the
highest authority and 5 stands for the lowest.)
SmartVoice Gateway(s) User Guide
YML832 Rev1
47