Webbing Psa Film - GBC Falcon 60+ Operation Manual

Operations Manual
Webbing PSA Film/Mount Adhesive
Using Threading Card
The laminator should be cool to the touch before
proceeding.
1. Turn the Power ON/OFF to on (I).
2. Load the rolls of film as illustrated in Figure 25. Ensure
no brake tension is applied to the film shafts.
3. Remove the safety shield and pivot the feed table
down.
4. Pull the top roll of film down under the idler bar and up
to the upper front rewind tube.
5. Place one piece of masking tape in the center of the
film and secure to the rewind tube.
6. Make two full wraps around the rewind tube, then care-
fully score the laminate without cutting the release liner.
Pull the laminate down allowing it to drape over the
upper heat roller (Figure 25).
7. Pull the mount adhesive up towards the film draped
over the upper heat roller (Figure 26).
8. Use a threading card to push the two materials through
the heat roller nip.
9. Pivot the table back to it's feeding position while
ensuring the threading card is on top of the feed table
(Figure 27).
10. Replace the safety shield.
11. Use the main roller pressure handle to bring the main
roller to initial contact with the threading card. Set speed
to 3 or less.
12. Set speed to 3 or less. Ensure forward ( ) is selected
and press the start (
13. From the rear of the machine, guide the web over the
chill idler, if installed, and through the pull rollers.
14. Once the web has entered the pull roller nip, use the
pull roller pressure handle to close the pull roller nip.
15. Press the stop (
) button Once the threading card
has completely exited the pull rollers,.
16. Open the main roller nip.
17. N o w r e f e r t o t h e s e c t i o n e n t i t l e d S TA R T
LAMINATING.
©2004 General Binding Corporation
) button.
60+ (-1)
FALCON
Fig 25
Fig 26
PSA
Film
Mount
Adhesive
Fig 27
CE
Page 25