Installation / Removal - Red Epic EPIC-M BUILD V3.3 Operation Manual

INSTALLATION / REMOVAL

WARNING: THE SIDE HANDLE IS NOT HOT SWAPPABLE - MEANING YOU CANNOT REMOVE OR
INSTALL WHILE THE CAMERA IS POWERED ON. BEFORE INSTALLING OR REMOVING THE SIDE
HANDLE, YOU MUST POWER DOWN THE CAMERA. FAILURE TO DO SO MAY RESULT IN
DAMAGE TO THE SIDE HANDLE AND / OR CAMERA BRAIN THAT IS NOT COVERED BY
WARRANTY.
To install the side handle:
1. Power down the camera if necessary.
2. Remove the brain side plate (if installed) by removing the single screw located at the bottom.
3. Rotate upwards to disengage lip at top of side plate from camera brain.
4. Insert the lip at the top of the side handle into the area where the lip from the side plate was installed.
Insert lip into top of
camera brain.
Rotate thumbscrew
upwards until tight.
5. Rotate side handle down flush along side of camera brain.
6. Rotate thumbscrew upwards until tight. Ensure side handle is secure to camera brain. You may have
to apply steady pressure to get the screw started.
955-0002_v3.3, Rev-B COPYRIGHT © 2012 RED.cm, Inc.
Remove screw and rotate side
plate upwards to remove.
Press side handle flush
against camera brain.
27 27