(Warning) Indicator - Epson EMP-730 User Manual

When Having Some Trouble

(Warning) Indicator

Indicator status
red
red
(0.5-second
intervals)
62
Cause
High internal The lamp will turn off automatically and
temperature projection will stop. Wait for about 5 minutes
without operating the projector. After 5 minutes
have elapsed, unplug the power cord and then plug
it back in again.
If the projector overheats, check the following two
points.
• Check that the air inlet and air outlet are clear,
and that the projector is not positioned against a
wall.
• If the air filter is dirty, it should be cleaned.
When the power cord is plugged back in, the
projector will return to its previous state, so press
the [Power] button on either the projector's control
panel or the remote control to turn it back on. If
the projector continues to overheat even after the
above points have been checked, or if the
indicators show a problem when the power is
turned back on, stop using the projector,
disconnect the power cord from the electrical
outlet, and contact your dealer or the nearest
address provided at "International Warranty
Conditions" in Safety Instructions/ World-Wide
Warranty Terms.
Problem with Disconnect the power cord from the electrical
lamp outlet and then remove the lamp and check if it is
broken. If the lamp is not broken, reinstall it. If the
lamp is broken, replace it. Then reconnect the
power cord and press the [Power] button on either
the projector's control panel or the remote control
to turn the power back on.
If the indicators still show a problem, stop using
the projector, disconnect the power cord from the
electrical outlet, and contact your dealer or the
nearest address provided at "International
Warranty Conditions" in Safety Instructions/
World-Wide Warranty Terms.
If the lamp is broken, remove it while being very
careful not to injure yourself on the broken edges,
and replace it with a new lamp. (Projection cannot
be carried out until the lamp is replaced.)
Check that the lamp and the lamp cover are
securely installed. If the lamp or lamp cover is not
securely installed, the lamp will not switch on.
: lit
Remedy or Status
: flashing
See
Page
15
75
78
78
78