Setting Up The External Sensor; Setting Up The Weather Station - Auriol Z29962A Operation And Safety Notes

Setting up the external sensor

Q 
Inserting the batteries:
j
Remove the battery compartment cover from
the back of the external sensor.
j
Insert two 1.5 V
the battery compartment
note: make sure that the polarity is correct.
This is indicated inside the battery compartment
(see Fig. D).
25
- The external sensor is now ready for operation
and the indicator LED
j
Close the battery compartment cover.
Installing the weather station and / or
external sensor on the wall:
note: you will need an electric drill for this step of
the installation.
m CaUTIOn! DanGER TO LIFE, RISK OF
InJURY anD MaTERIaL DaMaGE! Read the
operating and safety instructions for your drill care-
fully.
WaRnInG!
that you do not hit electricity, gas or water lines when
you drill into the wall. If necessary, check with a pipe
and cable detector before drilling.

Setting up the weather station

Q 
Inserting the batteries:
j
Open the battery compartment
of the weather station.
j
Place two 1.5 V
the battery compartment
note: take care that the polarity is correct. This
14 GB
batteries (AA) (included) in
25
lights up briefly.
23
DanGER TO LIFE! Take care
batteries (AA) (included) in
21
.
on the back
21
.