Extender Kit Installation - Tripp Lite B130-101A-MR Owner's Manual

Installation

Extender Kit Installation

(B130-101A-MR and B130-101A-SR)
Note:
1. If desired, perform the EDID copy procedure described in this manual prior to
2. Test to make sure the entire installation works properly before pulling cables
3. To achieve maximum distance and performance, 24 AWG solid-wire Cat5e/6
1
2
3
4
5
6
15-04-118-9333BE.indd 9
continued
Transmitter Unit
installation.
through ceilings/walls.
cable must be used. The use of stranded wire Cat5e/6 cable, or cable with a
gauge (AWG) size higher than 24 AWG will result in shorter extension distance.
All Tripp Lite N202-Series cables are made with 24 AWG solid-wire cabling.
Tripp Lite N022-01K-GY (Cat5e) and N222-01K-GY (Cat6) are 24 AWG solid-wire
bulk cables. For optimal image quality, use Zero-Skew cable such as Tripp Lite
P524-01K.
Make sure the VGA and audio source is powered off.
Connect the built-in VGA cable of the transmitter unit to the
computer's VGA port.
Connect a 3.5 mm audio cable from the transmitter unit to the
computer.
Connect the included Micro USB cable between the transmitter unit
and a USB port on the computer or USB wall outlet.
Using Cat5e/6 cable, connect the RJ45 OUTPUT port of the
transmitter unit to the RJ45 INPUT port of the receiver unit (see
Product Features section for your model's max distance information).
Connect the built-in VGA cable of the receiver unit to the monitor's
VGA port.
Receiver Unit
9
4/8/2015 10:35:10 AM