4. Adjusting the Printing Dot Mis-positioning
To adjust the amount of discrepancy of the dots in uni-directional and reciprocal directions, in 1/8 dot increments.
The procedures are explained below.
1.
Set paper in the printer.
2.
Turn on the power while pressing the FEED switch.
3.
After the buzzer beeps twice, release the FEED switch.
This enters the printing position adjustment mode.
4.
When the printing position adjustment mode is entered, a starting message is printed in one line.
("Position Adjusting Mode")
5.
Next, the printing position adjustment pattern shown below is printed.
The line that has an asterisk (*) is the current printer setting.
- -