Maintenance; Cleaning; Checks - Star SP700 Series Technical Manual

1. Maintenance

1-1. Cleaning

(1) Removal of dirt
Wipe off dirt with a soft cloth soaked in alcohol or benzine.
Note: Do not use thinner, trichlene or ketone solvents because they may damage plastic parts. Also during
cleaning, be careful not to moisten or damage electronic parts, wiring, or mechanical parts.
(2) Removal of dust, pile
Vacuum cleaning (with an electric cleaner) is preferred. Remove all dust, etc., inside the printer.
Note: After cleaning, check the oil level. If it is not adequate due to cleaning, replenish it.

1-2. Checks

Checks must be carried out at two levels: "a daily check" which the operator can easily carry out during operation, and a
"periodic check" which an expert should carry out.
(1) Daily check
When the printer is used on a daily basis, check that the printer is used properly. Make sure that the printer is
perating under the best conditions.
• Is the cartridge ribbon set at the right position?
• Is there any foreign matter inside the printer? (Remove if any.)
• Is the print head getting excessively dirty?
(2) Periodic check
After 6 months or printing 1 million lines, the periodic check and lubrication must be carried out.
• Check for deformation of springs.
• Check the gap between the platen and the print head.
• Remove dust, dirt, etc., around the detectors.
- 1 -