Hexadecimal Dump; Adjusting The Dot Alignment - Star XB24-250 II User Manual

Hexadecimal dump

This procedure prints in hexadecimal format all codes (character codes and
control codes) that are sent to the printer by the computer. The printer does not
execute any control codes (such as 0A - linefeed), it just prints them out. The
hexadecimal dump is useful when you are writing programs for printer control.
Make sure that paper is loaded in the printer.
Turn off the printer.
While holding down the control panel's FORM FEED button, turn the
printer back on to enter the Hex Dump Mode.
The printer will now print out the hexadecimal values of any data that is
subsequently sent to it from your computer.
To exit the Hex Dump Mode, first press ON LINE to set the printer off-line,
and then turn the printer off.

Adjusting the dot alignment

You may never have to use the procedure described in this section, but after you
have been using your printer for some time you may find that the dots of some
graphics do not align correctly. For example, what should look like:
may come out looking like one of the following:
This is caused when mechanical parts of the printer get out of alignment. This
happens only rarely and you may never experience it at all throughout the life
of the printer. If you do have problems, use the following procedure to correct it.
Make sure that paper is loaded in the printer.
Turn off the printer.
or like this
Hexadecimal dump 47