Adjusting The Print Head And Platen - Star SP700 Series Technical Manual

1-2. Adjusting the Print Head and Platen

1. To adjust the left side gap, remove the adjustment
bushing [4] screw in the left side frame and move the
adjustment bushing [4] up and down.
2. To adjust the right side gap, remove the adjustment
bushing [5] screw in the right side frame and move the
adjustment bushing [5] up and down.
3. Measure the gap as described in 1-1 above.
4. If the measurement value is not with 0.4 to 0.45, repeat
steps 1 and 2.
5. If the adjustment is within that range, tighten the screws
you loosened or removed.
Fig. 1-2 Adjusting the Gap (Left)
Gap
+
Fig. 1-3 Adjusting the Gap (Right)
-  -
-
[ 4 ]
Gap
-
[ 5 ]
+