Table of Contents
Advertisement
ELAN HOME SYSTEMS
Under Cabinet Installation
The VL10 is ideal for use installed underneath a kitchen or workshop
cabinet. This instruction assumes all pre-wiring has been previously
completed. To install VL10 under a cabinet:
1. Choose an appropriate mounting location underneath desired
cabinet or shelf.
2. Remove and remount the ELAN badge. Remove (2) screws from
rear panel location as shown in Figure 4-1. Remove the ELAN
badge, rotate it 180 degrees and replace. Tighten mounting
screws carefully. DO NOT OVER TIGHTEN.
3. Invert the image and touch screen input by placing the switch in
the rear most position, as shown in Figure 4-2.
© ELAN Home Systems 2011 • All rights reserved.
Figure 4-1 Badge Removal
Page 11
VL10
Advertisement
Table of Contents
