Elan vl10 Installation Manual page 13

E L AN H O M E S Y S T EMS
Figure 4-2 Image Inversion Switch
4. Measure the thickness of the bottom of the cabinet or shelf. Select
the shortest screw length that will pass completely through the cup
washer and cabinet shelf. Screw length must protrude from
underside of cabinet less than 0.5 inch. See Figure 4-4.
5. Using the provided VL10 Adhesive Backed Vinyl Mounting
Template, remove the protective backing material and carefully
place the template in position the bottom side of the cabinet. Make
sure the arrow on the template is pointing toward the forward edge
of the cabinet, as shown below in Figure 4-3. Drill out the 4 holes
shown on the template with a 3/16" drill bit.
Figure 4-3: Template Center Marks
© ELAN Home Systems 2011 • All rights reserved. Page 12
VL10