VIA!Valet6.4
INSTALLATION MANUAL
Installation (cont'd)
Under Cabinet Installation
The VIA!Valet6.4 is ideal for use installed underneath a kitchen or
workshop cabinet. This instruction assumes all pre-wiring has been
previously completed. To install VIA!Valet6.4 under a cabinet:
1. Choose an appropriate mounting location underneath the
desired cabinet or shelf.
2. Using the provided VIA!Valet6.4 Mounting Template, center
mark the four mounting hole locations. Make sure the
arrow on the template is pointing toward the forward edge of
the cabinet, as shown below.
3. Using a 3/16" drill bit, create four holes in cabinet from the
center marks made in Step 2.
Page 16
CENTERMARK
HOLES FOR MOUNTING
VIA!Valet6.4
© ELAN Home Systems 2005 • All rights reserved.
E L A N H O M E S Y S T E M S