Table of Contents
Advertisement
VIA!VALET100EM
Under Cabinet Installation
The VIA!Valet100EM is ideal for use installed underneath a kitchen or
workshop cabinet. This instruction assumes all pre-wiring has been
previously completed. To install VIA!Valet100EM under a cabinet:
1. Choose an appropriate mounting location underneath the
desired cabinet or shelf.
2. Using the provided VIA!Valet100EM Adhesive Backed
Mounting Template , carefully place the template in position.
Make sure the arrow on the template is pointing toward the
forward edge of the cabinet, as shown below in Figure 3-4 .
3. Using a 3/16" drill bit, create four holes in cabinet from the
center marks made in Step 2.
Page 16
DO NOT USE FOR VIA!VALET64
CENTERMARK
HOLES FOR MOUNTING
VIA!Valet100EM
Figure 3-4: Template Center Marks
© ELAN Home Systems 2008 • All rights reserved.
E L A N H O M E S Y S T E M S
Advertisement
Table of Contents
