Elan vl10 Installation Manual page 14

E L AN H O M E S Y S T EMS
6. Remove the factory installed screw-in rubber feet from the
underside of the VL10.
7. Make the required cable connections (Power, Ethernet and
optional Video) to the rear of the VL10.
8. Install the #6-32 screws through the cabinet bottom to the VL10
base. Secure the VL10 to the cabinet by tightening the four
screws by hand. DO NOT OVER TIGHTEN.
© ELAN Home Systems 2011 • All rights reserved.
Figure 4-4: Remove Feet
Figure 4-5: Base Mounting
Page 13
VL10