Connecting To The Mains Water Supply - Baumatic BWMI1206 Instruction Manual

o Mount the door and hinges to the front of the appliance using
screws (L).
o IMPORTANT: It is recommended that, where possible, the
décor door is hinged on the same side as the appliance
door as this will give greater space to load and unload the
washing.

Connecting to the mains water supply

o Connect and fully tighten the inlet hose to the threaded inlet
valve that is located at the rear of the washing machine. You
should connect the end with the right angle connector on it to
the back of your appliance.
o Connect the other end of the inlet hose to
your mains water supply. This machine only
uses cold water therefore only one hose is
needed to connect to the cold water supply.
DO NOT CONNECT TO A HOT WATER
SUPPLY.
o Tighten the inlet hose to your mains supply
fully.
o Test for any leaks.
33