Replacing The 14.1-Inch Display Panel; Removing The Display Latch - Dell Inspiron 4100 Manual

Removing and Replacing Parts: Dell Inspiron 4100

Replacing the 14.1-Inch Display Panel

1. Reconnect the top flex-cable connector to the display panel connector.
2. Reconnect the bottom flex-cable connector to the inverter connector.
3. Replace the tape that secures the display panel connector and the tape that
secures the middle of the display-feed flex cable to the display panel.
4. Place the bottom edge of the display panel in the bottom of the top cover and
elevate the top of the panel with your hand.
5. Lay the display panel in the top cover.
Reinstall the five M2 x 4-mm screws that secure the display panel to the top cover.
Display Latch
NOTICE: Disconnect the computer and any attached devices from electrical
outlets, and remove any installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by
touching an unpainted metal surface on the computer.

Removing the Display Latch

1. Remove the
2. Remove the
3. Remove the
4. Remove the two M2.5 x 5-mm screws and the two M1.7 x 3.5-mm screws that
secure the display latch and bracket to the top cover.
5. Lift the display latch and bracket up and out of the top cover.
file:///F|/Service%20Manuals/Dell/Inspiron/4100/remove.htm (33 of 58) [2/28/2004 7:04:06 AM]
hard drive.
display assembly.
display bezel.