Dell Inspiron 4100 Manual page 152

Removing and Replacing Parts: Dell Inspiron 4100
1 antenna cable
2 in-line connector
3 left speaker
4 mounting ring
5 left speaker holder
1. Remove the
2. Remove the keyboard.
3. Remove the
4. Remove the
5. Disconnect the speaker interface cable connectors.
NOTICE: Do not pull the antenna wire when removing the speaker.
NOTICE: Handle the speaker assemblies and speakers with care to avoid
damaging the speaker cones.
6. Remove the speaker assemblies by pulling them straight up and out of the
bottom case.
HINT: The left speaker has an in-line connector, and its antenna cable is longer
than the antenna cable of the right speaker.
Replacing the Speaker Assemblies
1. Place the mounting ring over the front palm-rest screw post.
NOTICE: Make sure the speaker wires are under their routing clips. Route the
left speaker wire properly between the battery bay and hard drive area.
2. Slide the speaker assembly down in to the bottom case.
file:///F|/Service%20Manuals/Dell/Inspiron/4100/remove.htm (51 of 58) [2/28/2004 7:04:06 AM]
6 antenna cable
7 right speaker holder
8 mounting ring
9 right speaker
hard drive.
display assembly.
palm rest.