Troubleshooting; Status Light Messages - NEC MultiSync GT2000 User Manual

6

TROUBLESHOOTING

This section helps you resolve problems you may encounter while setting up or using your MultiSync GT2000/GT2000R LCD
Projector.

Status Light Messages

Condition
OFF
On continually
Blinking very rapidly
(On and off in a cycle of 1 sec.)
Red
Blinking slowly
(On and off in a cycle of 8 sec.)
Blinking very slowly
(On and off in a cycle of 12 sec.)
On continually
Green
Blinking very slowly
(On and off in a cycle of 12
sec)
Status
Normal
The projector lamp has exceeded 2000 hours of operation and
should be replaced.
Either the lamp cover or filter cover is not fastened properly.
Check each and reattach them if necessary.
The cooling fan has stopped. Contact your NEC dealer for service.
The lamp is not turned on.
• The projector was turned off and back on too quickly. Turn
off the projector, wait one minute, then turn the projector
back on. Or the lamp is burnt out.
Normal (The projector is used with the ISS-6020 switcher in
bundled operation.)
The projector is not connected with the ISS-6020.
E-77