NEC GT5000 Control Commands
Nec gt5000: reference guide
Hide thumbs
Also See for GT5000:
- User manual (105 pages) ,
- Brochure & specs (12 pages) ,
- Installation manual (10 pages)
Related Manuals for NEC GT5000
Summary of Contents for NEC GT5000
- Page 1 Basic Serial Control Codes For NEC Projectors Models: GT5000/6000 MT860/1060/1065/1075 LT220/240/240K/260/260K WT600 VT770 VT46/465/460/560/660/660K HT1000/1100 Empowered by Innovation...
-
Page 2: Read First
NEC will supply more advanced control codes upon request. Please contact the NEC rep you purchased the projector from for more advanced control codes. In your request, you will need to give specific projector functions that you wish to control and only those codes will be supplied. -
Page 3: Cable Connection
None Communications: Full duplex NOTE1: It is recommended to set the projector to “Idle Mode” in the Setup menu for best Power ON response. NOTE2: Pins 1, 4, 6, and 9 are used inside the projector. NOTE3: Jumper “Request to send” and “Clear to Send” together on both ends of the cable to simplify cable connection. - Page 4 None Communications: Full duplex NOTE 1: It is recommended to set the projector to “Idle Mode” in the Setup menu for best Power ON response. NOTE 2: Pins 1, 4, 6, and 9 are used inside the projector. NOTE 3: Jumper “Request to send” and “Clear to Send” together on both ends of the cable to simplify cable connection.
-
Page 5: Pc Control Connector (Din-8P)
None Communications: Full duplex NOTE 1: It is recommended to set the projector to “Idle Mode” in the Setup menu for best Power ON response. NOTE 2: Pins 2, 3, 5, 6 and 8 are used inside the projector. NOTE 3: For long cable runs it is recommended to set communication speed within projector menus to 9600 bps. - Page 6 None Communications: Full duplex NOTE 1: It is recommended to set the projector to “Idle Mode” in the Setup menu for best Power ON response. NOTE 2: Pins 2, 3, 5, 6 and 8 are used inside the projector. NOTE 3: For long cable runs it is recommended to set communication speed in the Setup menu to 9600 bps.
- Page 7 None Communications: Full duplex NOTE1: It is recommended to set the projector to “Idle Mode” in the Setup menu for best Power ON response. NOTE2: Pins 1, 4, 6, and 9 are used inside the projector. NOTE3: Jumper “Request to send” and “Clear to Send” together on both ends of the cable to simplify cable connection.
- Page 8 Communications: Full duplex NOTE 1: Pins 2, 3, 5, 6 and 8 are used inside the projector. NOTE 2: For long cable runs it is recommended to set communication speed within projector menus to 9600 bps. Code Data PC Control Connector (DIN-8P)
- Page 9 None Communications: Full duplex NOTE 1: It is recommended to set the projector to “Idle Mode” in the Setup menu for best Power ON response. NOTE 2: Pins 2, 3, 5, 6 and 8 are used inside the projector. NOTE 3: For long cable runs it is recommended to set communication speed within projector menus to 9600 bps.