NEC MultiSync GT2000 User Manual page 66

Signal Name Entry Method
Select [Source Edit] [Name], then press the ENTER button to change to the
signal name entry display.
Here, the character entry and deletion methods will be described.
A maximum of 10 characters can be entered for the signal name.
Use the remote control number buttons and CTL button to enter the letters.
Example: Enter XGA
1) Enter X. (X is on the 8 button.)
Each press of the 8 button moves the selection through the sequence of
V W X 8 which repeats. Select X. To enter lower case and other charac-
ters, hold down the CTL button and select the characters.
2) Use the cursor / button to move the cursor to the next position.
Enter G and A using the same method as in Step 1).
* If a mistake is made, use the cursor
error, select the character, and correct it. To delete a character, press the CLEAR
button.
3) Press the ENTER button to set.
Correrspondence Table for Number Buttons and Letters
Number Buttons
1
c !
2
f "
g h i #
4
$
5
6
r &
7
u '
8
9
/ )
0
/ button to align the cursor with the
Press Directly
ABC1
DEF2
3
JKL4
MNO5
PQR6
STU7
VWX8
YZ?9
* , . 0
Name Input
Name Input
Name Input
Name Input
Name Input
Used with CTL
a b
d e
GHI3
j k l
m n o %
p q
s t
v w x (
y z
E-66
X
X
XGA
XG