Radio Reception - Sanyo DC-X801 Instruction Manual

DC-X801
Within approx. 7 meters
RB-X801
RB-X801 REMOTE CONTROLLER
Controls (Fig. 6)
Fig. 6
1. CD player function buttons
CD: CD function button
REPEAT: Repeat button
RANDOM: Random play button
MEMO: Memory/Check button
0 - 9 and +10: Track number buttons
44/44
and Wsi•i : Skip/Search buttons
: Stop button
►/11 : Play/Pause button
2. Tuner function buttons
BAND: Band button
PRESET: Preset button
- TUN +: Tuning buttons
3. Amplifier function buttons
TUNER: Tuner function button
TAPE: Tape function button
PHONO: Phono function button
VIDEO: Video function button
VOLUME - +: Volume buttons
The motor drive volume control can be adjusted by
using this remote controller.
" - " = decreased, "-i-" = increased
4. Battery compartment lid (back of the unit)
By using the remote controller, you can operate the system
in almost the same way as with the controls of the main unit.
Inserting batteries
1. Open the battery compartment lid by sliding the lid.
2. Install 2 "AA/SUM-3/R6" size batteries into the battery
compartment matching the polarity as shown in the
battery compartment.
3. Close the battery compartment lid.
Note:
Always remove batteries if the remote controller is not
going to be used for a month or more. Batteries left in the
unit may leak and cause damage.
Remote
control range
Use the remote controller within an angle of 30° at the left
and right horizontally and over distances up to about 7
meters straight ahead (Fig. 7).
Fig. 7
RADIO RECEPTION
Automatic or manual tuning operation
1. Turn on the power by pressing the POWER switch.
2. Press the TUNER FUNCTION switch.
(The last received station will be selected.)
- If any control switch of the tuner section are pressed,
source automatically switches to TUNER.
3. Select the desired radio band (FM1, FM2, FM3 or AM) by
pressing
the
BAND switch.
4. a. For automatic tuning, set the TUNING/FM MODE
switch to auto/stereo. (The AUTO indicator illumi-
nates.) Press either the "+" or " - " TUNING switch,
the unit will now search until it finds a radio broadcast.
Having done so it will stop on the best reception
frequency. Press either the "+" or " - " TUNING
switch again, for tuning the next broadcast station.
The automatic tuning may not receive a distant sta-
tion or weak-signal station.
b. For manual tuning, set the TUNING/FM MODE switch
to manual/mono. (The AUTO indicator goes out.)
Select the frequency of a desired station by means of
the TUNING switches. Press either the "+" or " - "
switch continuously until you are close to the desired
frequency and then briefly (and if required, repeat-
edly), press the appropriate switch until you have
reached the desired frequency.
5. For receiving an FM stereo broadcast, set the TUNING/
FM MODE switch to auto/stereo.
When an FM stereo broadcast is received, the FM STEREO
indicator illuminates. When a weak-signal FM broadcast
is received in stereo, press the TUNING/FM MODE
switch to manual/mono to improve reception. The FM
STEREO indicator goes out and the FM MONO indicator
illuminates.
6. Adjust the volume (POWER DRIVEN CONTROL), BAL-
ANCE and GRAPHIC EQUALIZER controls to the de-
sired sound level and sound equalization.
-3-