Controlling The System - jablotron JA-63 User Manual

Telephone line
digital bus
communication
88
display specifies mode of the control panel:
user mode
home arming
A section armed
B section armed
complete
key pressed
programming

3 Controlling the system

The system can by controlled by keypads, remote controls or by a PC with the
Comlink Software.
User codes
Can be used to arm and disarm the system or to reset an alarm. There can be up to
14 different user codes for individual users. The system stores to its memory which
code was used for which operation as well as the time &date of usage. This data can
go to a Central monitoring station and can also be viewed using a PC with Comlink
software. All user codes are empty as a factory default and should be programmed by
the supervisor (see section 4.2).
Alarm system JA-63 „Profi"
indicated event (Tamper or Failure) was caused
indicated event (Tamper or Failure) was caused
by a device (keypad or PC) connected to the
wireless keypad lost connection with the control
failure
error self testing error – call installer
tab. 1
authorized supervisor can test, bypass zones, change
batteries, record voice messages, program tel.
numbers and adjust internal clock in this mode
system is partially armed – particular detectors are
bypassed (someone remains in the house)
A section is armed (split system)
B section is armed (split system)
arming
warning that some detectors are bypassed –
bypass
waiting for more data to complete the entry
for installer programming and testing
mode
tab. 2
- 4 -
by the telephone line
digital bus
panel
system is completely armed
indicated while arming
MGK51504