Awc Setting - Sanyo VCC-9300P Instruction Manual

CAMERA SETTINGS
White balance additional settings (3)

AWC setting

1
Use the joystick lever (j or l) to move the cursor to
AWC next to WHITE BALANCE. Then press the ENTER
button.
The AWC SETTING screen will appear.
ENTER
2
With SET blinking for AWC LOCK, press the ENTER
button.
SET will light and adjustment of white balance will begin. After
about 3 seconds, SET will begin blinking again, signaling that
adjustment is complete.
ENTER
MEMO:
For even finer adjustment of coloration, choose SET for GO TO
MWB. White balance mode will become MWB for fine adjustment.
Note: Full adjustment may not be possible with just one activation
of SET for AWC LOCK. In that case, keep repeating the
press-and-hold activation of SET.
VIEW SETTING 1
IRIS AUTO ‚
WHITE BALANCE AWC ‚
SHUTTER OFF
MOTION OFF
APERTURE ON ‚
AWC SETTING
AWC LOCK SET
GO TO MWB SET ‚
MENU BACK
– 28 –
GO TO MWB setting
3
Use the joystick lever (j or l) to move the cursor to SET
for GOTO MWB and press the ENTER button.
The MWB SETTING screen will appear and the "R" value will
be blinking.
ENTER
4
Use the joystick lever (d or c) to adjust the value for "R"
(red).
Available settings: 0 – 255
5
Use the joystick lever (j or l) to move the cursor to "B",
then use the joystick lever (d or c) to adjust the "Blue"
value.
Available settings: 0 – 255
6
Canceling a settings screen
• • • •
Use the joystick lever (l) to select BACK for MENU, then
press the ENTER button. The VIEW SETTING screen will
reappear.
• • • •
To return to the normal screen, use the joystick lever (l
c) to select END for MENU, then press the ENTER button.
AWC SETTING
AWC LOCK SET
GO TO MWB SET ‚
MENU BACK
MWB SETTING
(OFFSET)
R 64
B 64
PRESET OFF
MENU BACK
English