Password Setting - Sanyo VCC-9300P Instruction Manual

CAMERA SETTINGS
5
Use the joystick lever (j l d c) to decide in which
direction the mask will be made.
6
Press the ENTER button.
The MASK NO SELECT screen will reappear.
7
Use the joystick lever (j or l) to move the cursor to a
mask number (Ex: MASK 3), and then use the joystick
lever (d or c) to change the setting to SET. Then press
the ENTER button.
The MASK 3 SET (POSITION) screen will appear, and SET
will be blinking. The gray mask will appear in the center of the
screen.
ENTER
MASK NO SELECT
MASK 1 OFF
MASK 2 OFF
MASK 3 OFF
MASK 4 OFF
MASK 5 OFF
MASK 6 OFF
MASK 7 OFF
MASK 8 OFF
DIRECTION SET ‚
PRESET OFF
MENU BACK
(About the POSITION screen)
It is possible to set as many as 4 masks on the same POSITION
screen. Even if a fifth mask is placed, SET will not appear.
Note:
• • • •
By stacking single screens with 4 masks on them it is possible
to set as many as 8 masks. See the example below for an
illustration of the use of 8 gray masks.
• • • •
Privacy masks can be set when the angle of the camera is
between 0 and 45 degrees. When the camera is beyond 45
degrees, a "*" mark will appear next to the screen title for
MASK NO. SELECT and DIRECTION to indicate that a mask is
not possible at this angle.
• • • •
The area under a mask can be seen when the camera is
changing preset positions. To compensate for this, make the
masks a little larger when necessary.
(DIRECTION)
MASK 3 SET
(POSITION)
SET ‚
– 16 –
8
Use the joystick lever (d or c) to move the gray mask,
then press the ENTER button.
The SIZE screen will appear, and the mask that was
positioned in the POSITION screen will be displayed.
ENTER
9
Use the joystick lever (d or c) to adjust the size of the
gray mask, then press the ENTER button.
The MASK NO SELECT screen will reappear, and the setting
for MASK 3 will be "ON".
MEMO:
• • • •
At the bottom of the screen, PRESET and MENU items will
appear. To make additional settings, move the cursor to
BACK for MENU and press the ENTER button. The MASK
NO SELECT screen will reappear.
• • • •
If you are done making settings, change BACK to END
and press the ENTER button.

PASSWORD setting

You can lock the privacy masks in place after they have been set.
The password requirement is initially set to OFF, but to begin using
it, you must enter the factory set password "1234".
1
Use the joystick lever (j or l) to move the cursor to OFF
for PASSWORD LOCK in the PRIVACY MASK SETTING
screen. Then press the ENTER button.
The PASSWORD screen will appear.
ENTER
MASK 3 SET
(SIZE)
PRESET OFF
MENU BACK
PRIVACY MASK SETTING
PASSWORD LOCK OFF ‚
PASSWORD CHANGE SET ‚
MASK SET SET ‚
PASSWORD
MENU BACK
**** SET ‚
-
MENU BACK
English