安裝說明 Installation Instructions - German pool PAC-10 Operating Instructions Manual

安裝說明
F.電源
- 確保插頭並無損壞，並檢查電壓是否正確。
- 將插頭插入插座，並開啟插座開關，然後按
本機之"開關"鍵。
- 拔除插頭或移動本機時，切勿用力拉電源線。
為了預防漏電危險，請避免電源線受損。
G. 安裝窗口密封板
- 將接合器安裝於窗口密封板上。窗口開口
闊度應與密封板配合。
- 用螺絲釘通過小孔固定所需長度，密封板
度可伸延至約 1.5 m 。
上下式趟窗口
Upward Sliding Window
水平安裝
Horizontal
H.使用暖風時改變排氣管安裝方向
使用暖風功能前，按圖Fig.G1及Fig.G2箭頭方向
所示，將出風口蓋及排氣管連蓋分別拆出。然後
互換及安裝，完成圖如Fig.G3所示。
Fig. G1
Installation Instructions
(按需要選用)
F. Power Supply
- Make sure the plug is not damaged. Check if
the voltage is correct.
- Insert plug into the socket. Turn on socket switch
and then press "POWER" to run the machine.
- Do not tug the power cord when pulling out the
plug or moving the machine. In order to prevent
leakage, avoid scarring the cord.
G. Installation of Window Sealplate
- Put pipe connector into window sealplate.
Adjust window opening width, so that the
sealplate matches with the window properly.
- Secure the sealplate with nails via the small
holes on it.The length of the sealplate can be
extended to about 1.5 m.
垂直安裝
Vertical
H. Change of Exhaust Pipe Installation
for Heating
Before using the heating function, disassemble
the air outlet cover and the exhaust pipe with cover
according to the arrows' directions (Fig. G1 & G2).
Then, exchange the two assemblies and install.
The finished illustration is as Fig.G3.
Fig. G2
P.11
左右式趟窗口
Left-Right Sliding Window
Fig. G3
(Optional)