Panasonic DBS 576 Technical Manual page 12

Section 521
Example:
SEARCH 2,015,010
03:No Ans Timer
Enter The AGENT
No Ans Time.
1 to 600 sec.
List→
Note:
• The program line is updated when the final parameter setup is completed at
• If you press soft key 10 and select List at any of the above steps, the List
• The END/DISC line cannot be changed nor deleted.
INSERT (FF2)
This command inserts a new line in the current setting of displayed program
lines. Insertion can be repeated up to 19 lines.
The following screen display shows an example of insertion and setting of the
SEARCH command.
01:Select Cmd.
FWD FWDVM
PLAY RET
SEARCH
List→
12
4. Set parameter 3, and press the HOLD key.
Example: Enter three digits to set the No Ans Timer.
The program line that was set is updated when the final parameter
is set. The next line is moved to, and the screen in step 1 is
redisplayed.
5. Repeat steps 1 to 4 to set other program lines, and end
programming at the END/DISC line.
each command, and the next line is moved to. (Example: In the case of the
FWD command, the program line is updated when the no answer timer of
parameter 2 is input, and the next line is moved to.)
Mode screen is redisplayed.
1. Press the soft keys (1 to 6) for the commands to be set, and press
the HOLD key.
Example: Press soft key 3 to select SEARCH.
DBS 576 (USA) issued March 1999
Built-In ACD Supervisor Guide
576-25-521 (ACD 3.0)