LG LNB7210 Owner's Manual page 26

Additional Detect (Available up to three)
> To set the detect area
1. Set to [ON] the desired algorithm.
2. Click the [Set Zone] or [Set Line] button.
3. Click the left mouse button on the screen to set the detect
area.
- Intrusion: When the perceived object is(are) move into
the event area, the Intrusion Event is activated.
- Object Removal: When the object is disappear from the
setting area, the Object Removal Event is activated.
- Object Desertion: When the object is placed in the
setting area, the Object Desertion Event is activated.
- Crossing Line: When the perceived object go through a
setting lines, the Crossing Line Event is activated.
- Object Counting: When the perceived object go through
a setting line, the Object Counting Event is activated.
4. Click the [Save] button to confirm the settings.
Note:
• You can select an algorithms up to 3.
• It is possible to set in area up to octagon from triangle, and
can be set only convex polygon.
• To finish the area setting, click right mouse button. In case of
octagon, it is finished to click the last point.
• While set an area, if you click the right mouse button over
the point, the point is canceled.
• In case of [Intrusion], [Object Removal], [Object Desertion]
algorithms can set the detect area and [Crossing Line],
[Object Counting] algorithms can set the direction of
detection.
• When detection occurs, the text is displayed at the right of
detection configuration. ("Detected" or "Not Detected")
• When the area setting and activating of [Object Removal]
and [Object Desertion] are finished, detection will start in
10 seconds to set the initial background.
• [Object Removal] and [Object Desertion] are activated
when the detected object is being in same condition
for 10 seconds.
• [Object Removal] and [Object Desertion] need up to
5 minutes to recognize the object as the background.
• Depending on your installation environment, it may occur
detection error or performance degradation of image
analysis.
26
Triggered Event
When an event (VA/ Motion detect/ Sensor Event/Audio detect)
occurs, this unit records the live images and routes as configured.
Event schedule list
> To edit the Event Schedule
1. Select the Trigger event and click the [Edit] button. Event
schedule window is displayed.
2. Set the options.
• Trigger: Display the selected trigger event and the
current state of trigger. Current state of trigger is
Displayed to On or Off.
• Time: Sets the weekday, Start, Finish, Pre alarm, Post
alarm and Ignore interval time options.
• Action: Selects the options. This occurs when the
event runs.
- FTP(Video) server/SMTP server: Uploading of
images to an FTP server, or e-mail notification.
- Control relay: The relay is activated or
deactivated.
- SD Card recording: Record on the SD card when
the event runs.
- Move camera to (Applicable model: [Sensor] in
LNB7210): Write the number of the preset, the
camera would Move to this preset when the relay
is activated.
- FTP server(JPEG): Sends the JPEG Image to
the FTP server. Image file and suffix setting is
available. You can select Date/Time or Sequence
of Suffix.
• Stream: Selects the stream of the connected camera.
3. Click the [Save] button to confirm the settings.
Note:
• You should register the SMTP and FTP server on the
Event server setting to set this function.
• Recording of event(VA/ Motion detect/ Sensor Event/
Audio detect) runs every 5 minutes split file.
• Used stream is profile1(1st) in case of FTP(JPEG)
transmission.
• When the [External] mode in [Day/Night] menu is used,
the [Sensor] is deactivated.
Operation and settings