LG LNV7210 series Owner's Manual

OWNER'S MANUAL
High
Definition
Network
Camera
Please read this manual carefully before operating
your set and retain it for future reference.
MODEL
LNV7210 series LNV7210R series
Specification
Item LNV7210R series LNV7210 series
Image Device 6.4 mm (1/2.8 Type) CMOS
Lens Type 3 mm to 9 mm F1.2 (x3 Zoom)
Day / Night ICR (Auto / Day / Night / External / Schedule)
Color: 0.03 lx @ F1.2 (1/30 sec, 50 IRE)
Minimum
B/W: 0.003 lx @ F1.2
Illumination
B/W: 0 lx @ IR LED on
(1/30 sec, 50 IRE)
Camera
WDR Support
IR Distance
(LNV7210R 20 m
only)
Backlight Compensation, 2D+3D-DNR, De-fog, Exposure Control,
Image
AGC, White Balance, Privacy Masking, Sharpness, EIS, Pivot,
Enhancement
SmartIR (LNV7210R only)
Compression H.264, H.264_High, MJPEG
Resolution 1920 x 1080 / 1280 x 720 / D1 (704 x 576) / CIF (352 x 240)
Maximum
60 fps @ 1920 x 1080
Frame Rate
Multi-
Up to 4
Streaming
ROI (Smart-
Support (Up to 8)
Codec)
Video /
Motion detection, Tampering alarm, Face detection, Intrusion
Audio
Video Analytics detection, Crossing line, Object counting, Object removal, Object
desertion
Text Overlay Support
Audio
G.711, G.726
Compression
2-way Audio Support
Audio
Support
Detection
Event Trigger Video analytics, Audio detection, Alarm input
Event
Relay Out, Email, FTP
Event Notification
Pre Event
Support
Buffering
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER (OR BACK)
NO USER-SERVICEABLE PARTS INSIDE
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
This lightning flash with arrowhead symbol within an equilateral triangle is
intended to alert the user to the presence of uninsulated dangerous voltage
within the product's enclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the
user to the presence of important operating and maintenance (servicing)
instructions in the literature accompanying the product.
WARNING: This product contains chemicals known to the State of California to cause cancer and
birth defects or other reproductive harm. Wash hands after handling.
FCC WARNING: This equipment may generate or use radio frequency energy. Changes or
modifications to this equipment may cause harmful interference unless the modifications are
expressly approved in the instruction manual. The user could lose the authority to operate this
equipment if an unauthorized change or modification is made.
REGULATORY INFORMATION: FCC Part 15
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio
communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense.
• A suitable conduit entries, knock-outs or glands shall be provided in the cable entries of this
product in the end user.
• Caution: Danger of explosion if battery is incorrectly replaced. Replaced only with the same or
equivalent type recommended by the manufacturer. Dispose of used batteries according to
the manufacturer's instructions.
• Holes in metal, through which insulated wires pass, shall have smooth well rounded surfaces
AB28
or shall be provided with brushings.
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
Warning: Do not install this equipment in a confined space such as a bookcase or similar unit.
Warning: Wiring methods shall be in accordance with the National Electric Code, ANSI/NFPA 70.
Analog Out BNC out
Audio In / Out 1 / 1
Interface
Alarm In / Out 1 In / 1 Out
SD Slot micro SD (Up to 32 GB)
Ethernet RJ-45 10 / 100 BASE-T
Security Password protection, HTTPS (SSL, TLS), IP filtering, IEEE 802.1X
Open Protocol ONVIF 2.2 Profile S, PSIA 1.1
IPv4 and IPv6 : TCP/IP, UDP, HTTP, HTTPS, RTP, RTSP, DHCP, ICMP,
QoS
Network
Protocol
IPv4 : FTP, SMTP, NTP, ARP, SNMP v1/v2c/v3, DDNS(LG)
Integrated LG Ipsolute VMS Suite / Mobile application (iPhone, iPad,
Software Android)
Connections Up to 20
Power Source DC 12 V, PoE
Maximum
Power 8.7 W (DC 12 V), 10.4 W (PoE 48 V)
Consumption
Maximum
730 mA (DC 12 V), 280 mA (PoE)
Input Current
General
Operation
Temperature / -10 ºC to 50 ºC / 0 % RH to 80 % RH
Humidity
Dimension
140 mm x 122 mm
(Ø x H)
Weight 980 g
Component
Camera, CD (Software and Owner's Manual), Installation Manual, Test monitor cable, Wrench,
Screws (4 EA), Installation sticker, Camera mounting bracket
Warning: This is a class A product. In a
domestic environment this product may cause
radio interference in which case the user may
be required to take adequate measures.
Warning: To reduce a risk of fire or electric
shock, do not expose this product to rain or
moisture.
Warning: Please adopt the power adapter
which can meet the safety extra low voltage
(SELV) standard. And source with DC 12 V or
AC 24 V (depending on models) according
to the IEC60950-1 and Limited Power Source
standard.
Warning: Install the camera on a ceiling
or wall where can withstand the weight of
5 times of the camera including mounting
bracket.
Caution: This installation shall be made by a
qualified service person and shall conform to
all local codes.
Caution: To avoid electrical shock, do not
open the cabinet. Refer servicing to qualified
personnel only.
Caution: The apparatus shall not be exposed
to water (dripping or splashing) and no objects
filled with liquids, such as vases, shall be
placed on the apparatus.
Caution: Make sure the power supply voltage
is correct before using the camera.
Caution: Do not drop the camera or subject it
to physical shock.
Caution: The sensor may be burned out by
a laser beam, so when any laser equipment is
being used, make sure that the surface of the
sensor not be exposed to the laser beam.
Caution: While shipping, the camera should
be packed in its original packing.
Note:
Please make sure the product is installed
appropriate places where secured from flood,
such as under the eaves, to operate properly.
This product is certified as IP66 standard.
However, if there is any flood concerns, it
is highly recommended to use an outdoor
Housing. When you install the camera inside
an outdoor Housing, please use one of the
following methods:
1. Remove the front glass of Housing before
installing the camera.
2. To keep the front glass of Housing,
remove the front cover, and then put the
camera close to the front glass.
Part Names and Functions
a
b
c
d
e
f
g
975 g
l
Important Safety
To disconnect power from mains, pull
out the mains cord plug. When installing Instructions
the product, ensure that the plug is easily
1. Read these instructions.
accessible.
2. Keep these instructions.
LG Electronics hereby declares 3. Heed all warnings.
that this/these product(s)
4. Follow all instructions.
is/are in compliance with the
5. Do not use this apparatus near water.
essential requirements and
6. Clean only with dry cloth.
other relevant provisions of
7. Do not block any ventilation openings.
Directive 2004/108/EC and
Install in accordance with the
2011/65/EU.
manufacturer's instructions.
Contact office for compliance of this
8. Do not install near any heat sources such
product:
as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that
LG Electronics Inc.
produce heat.
EU Representative, Krijgsman 1,
9. Do not defeat the safety purpose of
1186 DM Amstelveen, The Netherlands
the polarized or grounding-type plug.
• Please note that this is NOT a Customer
A polarized plug has two blades with
Service contact point. For Customer
one wider than the other. A grounding
Service Information, see Warranty Card
type plug has two blades and a third
or contact the dealer that you purchased
grounding prong. The wide blade or the
this product.
third prong are provided for your safety.
If the provided plug does not fit into
Disposal of your old appliance
your outlet, consult an electrician for
replacement of the obsolete outlet.
1. When this crossed-out
10. Protect the power cord from being
wheeled bin symbol is
walked on or pinched particularly at
attached to a product
plugs, convenience receptacles, and the
it means the product is
point where they exit from the apparatus.
covered by the European
11. Only use attachments/accessories
Directive 2002/96/EC.
specified by the manufacturer.
2. All electrical and electronic products
12. Use only with the cart, stand, tripod,
should be disposed of separately from the
bracket, or table specified by the
municipal waste stream via designated
manufacturer, or sold with the apparatus.
collection facilities appointed by the
When a cart is used, use caution when
government or the local authorities.
moving the cart/apparatus combination
3. The correct disposal of your old appliance
to avoid injury from tip-over.
will help prevent potential negative
consequences for the environment and
human health.
4. For more detailed information about
disposal of your old appliance, please
contact your city office, waste disposal
service or the shop where you purchased
the product.
13. Unplug this apparatus during lightning
EEE Compliance with Directive. storms or when unused for long periods
of time.
(for Turkey only)
14. Refer all servicing to qualified service
personnel. Servicing is required when
a Dome Cover
b IR Sensor (LNV7210R only)
c IR LED (LNV7210R only)
NOTE:
Do not stare at operating IR LED within hazard distances (1 m).
d micro SD card slot
Insert the micro SD card.
e Jog button
Use this button for control the Zoom / Focus of the camera.
f Video Out Connector
Use this jack for checking the picture with portable monitor when install the camera.
g RESET button
Push the button more than 3 seconds, this would restore the factory default network
related settings.
h AUDIO IN / OUT (Line Level Input/ Output)
i ALARM IN & OUT / ALARM IN & OUT RETURN
h i jk
Provides physical interface for sensor and Alarm/Relay.
j Power input terminal
Connects to a DC 12 V power supply using proper cables. This camera must always be
operated a DC 12 V. Certified/Listed Adaptor which comply with LPS.
k ETHERNET / PoE Port
Connects to a PC or a network via a hub with a 10 BASE-T / 100 BASE-TX cable attached
RJ-45 connector.
NOTE:
Power over Ethernet (PoE) is a technology that integrates power into a standard LAN
infrastructure. It enables power to be provided to the network device, such as a network
camera, using the same cable as that used for network connection. It eliminates
the need for power outlets at the device locations and enables easier application of
uninterruptible power supplies (LPS).
l Camera mounting bracket
You can lock the camera mounting bracket by tighten the screws.
the apparatus has been damaged in any
way, such as power-supply cord or plug
is damaged, liquid has been spilled or
objects have fallen into the apparatus, the
apparatus has been exposed to rain or
moisture, does not operate normally, or
has been dropped.
Handling of the unit
Be careful not to spill water or other liquids on
the unit. Be cautious not to get combustible or
metallic material inside the body. If used with
foreign matter inside, the camera is liable to
fail or to get cause of fire or electric shock.
• Remove dust or dirt on the surface of the
lens with a blower.
• Use a soft and lint-free, dry cloth(such as
glass cleaner) to clean the body. If it is
very dirty, use a cloth dampened with a
small quantity of neutral detergent then
wipe dry.
• Avoid the use of volatile solvents such
as thinners, alcohol, benzene and
insecticides.
They may damage the surface finish and/
or impair the operation of the camera.
• This camera is designed for mounting on
the ceiling or wall. If you install this camera
upside down, it may cause malfunction.
Operating and storage
location
Avoid viewing a very bright object (such as
light fittings) during an extended period. Avoid
operating or storing the unit in the following
locations.
• Extremely hot or cold places (operating
temperature -10 °C to 50 °C, however, we
recommend that the unit be used within
a temperature range of 0 °C to 45 °C)
• Damp or dust place
• Places exposed to rain
• Places subject to strong vibration
• Close to generators of powerful
electromagnetic radiation such as radio
or TV transmitters.
• Do not use the camera in such place
where rapid temperature fluctuation by
switching an air conditioner on and off.