LG LNB7210 Owner's Manual page 25

Motion Detect
Preview
You can preview the motion detection window on the preview
window.
General
> Sensitivity: Enter the sensitivity to detect an object in
motion.
• Save: Click this button to confirm the settings.
How to set the motion detect window
1. Click the [Add] button. The motion detect window is
displayed. You can add the three windows maximum for
motion detection area.
2. Set the [Sensitivity] option.
3. Click the edge or corner of the window box to adjust the
window size for motion detection.
4. Click the [Save] button to save the settings.
Note:
• Created motion detection area window will be applied for the
same sensitivity at once.
• Increase the sensitivity in the environment with a low lighting
condition or a few motion. On the contrary, in the environment
with a high lighting condition or a lot of motion, decrease the
sensitivity.
• The Motion Detection function may not work depending on
your installation environment.
• Motion Detection settings area is not maintained by the screen
change by the operation of Pan / Tilt / Zoom. When reset the
Pan / Tilt / Zoom, you need to reset the Motion Detection
settings area also.
• You can reset the window size. Click one of the window edge or
corner and drag & drop to reset the motion detection area.
• Motion Detection can be activated when at least one of
channels is enabled, Video codec is set to H.264 and GOP size is
more than 2.
Operation and settings
Audio detect
Audio Detection
> Enable: Set to [ON] or [OFF]. The Basic Configuration menu is
displayed when selects [ON].
Basic Configuration
> Level: Select the level of audio detection from the
drop-down list. You can set the level using by jog control.
If you use jog control, the [Level] option is set to [Manual]
automatically.
> Input Graph: Displays at intervals 0.5 seconds within 25
seconds cumulative graph.
> Audio Detect Status: Displays the audio is detected or not.
• Save: Click this button to confirm the settings.
Smart Analytics
Preview
You can preview the camera image on the preview window.
Basic Configuration
> Tamper Detect: Detect changes on the screen and operate
in accordance with the registered Event.
- Enable: Set to [On] or [Off ].
> Face Detect: Detect the recognized face on the screen and
operate in accordance with the registered Event.
- Enable: Set to [On] or [Off ].
- Sensitivity: Set the [Sensitivity] option.
Note:
When the value is closer to the [Highest] detects
sensitively, and when the value is closer to the [Lowest]
detects insensitively.
25