Operating Instructions - JB Systems COB-4BAR Operation Manual

ENGLISH
IR ACTIVE
Activate this function If you want to control the 4BAR with the small wireless remote control.
Always deactivate this function when you don't want to use the wireless remote control.
 Press the MODE button until IR ACTIVE is shown on the display.
 Press the ENTER button to enter the configuration mode
 Use the DOWN and UP buttons to select ON (wireless controller can be used) or OFF (cannot be
controlled via the wireless remote controller)
 Press the ENTER button to confirm
IMPORTANT: If you don't want to use the wireless remote controller, you need to deactivate the IR
remote control receiver in the bar. (IR ACTIVE = OFF)
LIGHT EFFECT OUT (only when controlled via DMX)
With this option you can decide if the 2 extra power outputs for extra light effect (12) and (13) can be
turned ON/OFF via DMX or if the power needs always to be ON
 Press the MODE button until LIGHT EFFECT OUT is shown on the display.
 Press the ENTER button to enter the configuration mode
 Use the DOWN and UP buttons to select DMX CONTROL ON (the power outputs can be switched on or
off via DMX) or DMX CONTROL OFF (the power outputs are continuously ON)
 Press the ENTER button to confirm

OPERATING INSTRUCTIONS

A. Standalone 1unit:
 Just connect the projector to the mains.
 Select one of the automatic, sound or static color modes
 Refer to chapter HOW TO SETUP to learn how to make the settings.
B. Two or more units in master/slave setup:
 Connect the units together. Refer to the chapter "electrical installation" to learn how to do this.
 Select one of the automatic, sound or static color modes on the master (the first COB-4BAR in the
DMX chain)
 Set all the other bars in SLAVE mode
 The projectors will now follow the program of the master COB-4BAR so they all work synchronously.
C. Controlled by the wireless remote controller:
To be able to use the wireless remote control, you need to enable this option in the 4BAR:
 Press the MODE button until IR ACTIVE is shown on the display.
 Press the ENTER button to be able to change the setting
 Use the DOWN and UP buttons to enable or to disable the remote control option (ON = remote control
enabled, OFF = remote control disabled).
 Press the ENTER button to confirm
 Press the MODE button until SLAVE & FOOT CONTROL is shown
on the display.
 Press the ENTER button to confirm
Functions:
 BL: is used to switch the LEDs off/on
 SP: is used to set the running speed when you are using the color
change or the color fade modes. Press this button several times to
select one of the 4 preprogrammed speeds. (Slow, medium, fast, off)
 BRIGHTNESS (Master Dimmer): is used to set the General
brightness of your projectors. Press this button several times to select
one of the 4 preprogrammed brightness levels. (50%, 75%, 100%,
off)
 FL: is used to activate the strobe (Flashing) mode. Press this button
several times to select one of the 4 preprogrammed flash
frequencies. (Slow, medium, fast, off)
 R is used to set the intensity of the Red LED source. Press this button
several times to select one of the 4 preprogrammed brightness levels.
JB SYSTEMS
®
8/74
USER MANUAL
COB-4BAR